Specifications

Chapter 9 - AdeptVision VME Module (VIS)
116 Adept MV Controller User’s Guide, Rev C
9.8 Camera Cable Pin and Signal Information
This section provides the pin and signal information for the connectors and cables
associated with the AdeptVision VME product.
• Table 9-3 describes the Hirose connector that is used for all cameras on both the
two- and four-camera breakout cables.
• Table 9-4 describes the Strobe and Power connector on the four-camera breakout
cable.
• Table 9-5 describes the 10-meter camera cable.
• Table 9-6 describes signal information between the 44-pin connector and the
camera connectors for the two-camera breakout cable.
• Table 9-7 describes signal information between the 44-pin connector and the
camera and strobe/power connectors for the four-camera breakout cable. The
table is organized by camera number.
• Table 9-8 contains information similar to Table 9-7, only it is organized numerically
by the 44-pin connector.
Table 9-3. Breakout Cable Camera Connector Pin Assignments
Pin Function Notes
1Power return
2 +12V power to camera
3 Shield (video)
4 Video from camera
5Shield(Hd)
6 Hd (horizontal drive) to camera
7 Vd (vertical drive) to camera
8 Shield(Clock) to camera (camera 1 & 2 only)
9 Clock to camera (camera 1 & 2 only)
10 not connected
11 not connected
12 Shield (Vd)
12-Pin Hirose Female Jack, HR10A-10J-12S
This connector will normally be connected to the camera via the optional
10-Meter Adept MV Camera Cable.
For special applications, this connector will mate with a Hirose Male Plug
HR10A-10P-12P (user supplied) or similar.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com