Specifications

Installing Camera Cables
Adept MV Controller User’s Guide, Rev C 115
9.7 Installing Camera Cables
Refer to the AdeptVision VME User’s Guide for information on mounting cameras and
strobes in your system. Figure 9-5 shows the installation of a typical four-camera breakout
cable and the associated hardware.
CAUTION:
Turn off the controller before installing or removing a camera
or cable. Failure to do this may damage the VIS module.
When using the four-camera breakout cable, you must provide 12 VDC power at
sufficient current for the type and quantity of cameras you are using. See the
documentation supplied with your cameras for information on current requirements.
Figure 9-5. Camera Cable Installation Drawing
!
C
A
M
E
R
A
S
/
S
T
R
O
B
E
S
VIS
P
O
I
N
T
E
R
1
2
3
4
ON
2
3
41
M
O
N
I
T
O
R
KEYBOARD
OK
VGB
Strobe/Power
Connector
User 12VDC
Power Supply
to Drive
Cameras
User-Supplied
9-pin Male D-Sub
Connector
Up to Two
Optional
Strobe
Lamps
Video Bus Coupling
Installed
Up to four cameras
can be installed.
Four-Camera
Breakout Cable
10-Meter Camera
Cable, one for
each camera
VIDEO
BUS
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com