Setup guide

VISTA-32FB Installation and Setup Guide

4-8

Using the a Relay to Unlock A Door

This control can be programmed so that a user can

trigger a relay for 2 seconds (e.g., to unlock a door) by

entering the User Code + [ 0 ].

To program a relay for this purpose, perform the

following steps::

Step Action

1 Enter Output Programming in the #93 Menu

Mode.

Step Action

2 Program the output type as 1, or 2.

3 For type 1, program the ECP address and

relay number.

4 For type 2, program the house and unit codes.

Program the relay number in field 1∗76

(partition-specific).

See Output Programming in the Programming Guide

for a detailed explanation.

Programming for ECP Communications Device

• Program the Communications Device in Device

Programming in the #93 Menu Mode Programming.

• Program field ✳56: Selects the time the panel

should wait before it attempts to send a message to

the second destination..

• Program field ✳57: Selects the initial reporting

destination for messages.

• Program field ✳58: Selects events for the primary

sub’s ID

• Program field ✳59: Selects events for the secondary

sub’s ID.

Programming for the Event Log

• Program field 1✳70 Event Log Types (1=enable;

0=disable for each type)

• Program field 1✳71 12/24-Hour Time Stamp

Format (0=12 hr; 1=24 hr)

• Program field 1✳72 Event Log Printer On-line

(0=disable; 1=enable)

• Program field 1✳73 Printer Baud Rate (1=300;

0=1200)