Setup guide

LINE SEIZE...................................................................C-1
List of Figures.................................................................vi
LO BAT....................................................................... 10-4
Lobby Partition ............................................................ 5-7
Log First Maintenance Signal................................... 5-11
LOG RESULTS?......................................................... 10-2
Long Range Radio ECP Programming ...................... 4-8
Low Speed Format (Primary)...................................... 5-4
Low Speed Format (Secondary)................................. 5-5
LRR Battery................................................................ 3-26
LRR CRC is bad......................................................... 3-26
LRR Trouble Messages............................................. 3-26
LSENS ........................................................................ 10-4
Main Logic Board Supervision Type 28..................... 4-7
Manager Codes Level 2............................................... 9-1
Master Codes Level 1.................................................. 9-1
Master Keypad............................................................. 2-4
Maximum Number of Dialer Attempts...................... 5-14
Mercantile Premises Listing....................................... 3-3
Mercantile Safe and Vault Listing ....................... 3-1, 3-4
MODEM COMM ................................................... 7-1, 10-4
modems........................................................................ 7-1
Momentary Exit Type 29 ............................................. 4-7
Mounting The Control Cabinet ............................ 3-1, 3-3
Multi-Access ?............................................................. 9-3
Multiple Alarms............................................................ 5-2
Multiple Partition Access............................................ 9-2
MX8000 Receiver ....................................................... 3-12
No Alarm Response Type 23...................................... 4-7
Normally Closed or EOLR (Zones 2-8)....................... 5-4
Notification Appliance Circuit Supervision............... 3-7
Number of Partitions................................................. 5-11
OC or OPEN CIRCUIT.................................................. 3-6
Off-Normal Report ..................................................... 10-4
On-Line Control Functions ......................................... 7-2
Open/Close Reporting................................................. 9-2
Open/Close Reports by Exception.................... 5-12, 6-3
Open/Close Schedule.................................................. 6-3
Open/Close Schedule Programming ......................... 6-7
Open/Close Schedules......................................... 6-5, 6-6
Open/Close Windows.................................................. 6-9
Operator Access Levels.............................................. 7-1
Operator Codes Levels 3-5......................................... 9-1
Output Device Control Commands............................B-1
Output Devices.......................................................... 3-21
OUTPUT PGM .............................................................. 4-3
Overvoltage Protection............................................. 3-12
PABX Access Code..................................................... 5-3
Panic Button or Speedkey.......................................... 5-9
Partitioned System...................................................... 2-1
Partitioning ........................................................... 1-1, 2-1
Partition-Specific Data Fields..................................... 4-2
PassPoint Access Control (ACS) Type 10................. 4-7
Perimeter Type 03 ....................................................... 4-6
Peripherals Devices .................................................... 1-1
Permanent Keypad Display Backlighting................ 5-10
Phone Module Access Code ...................................... 5-2
PLL out of Lock ......................................................... 3-26
polling loop ................................................................ 3-16
Polling Loop Current Draw....................................... 3-28
Polling Loop Devices ................................................ 3-16
Polling Loop Supervision ......................................... 3-17
Power Failure............................................................. 10-4
Power Supply Load ................................................... 3-27
Power Unattained ...................................................... 3-26
Power-Up in Previous State........................................ 5-3
Prevent Zone XXX Bypass.......................................... 5-4
Primary Format............................................................ 5-4
Primary Phone Number .............................................. 5-3
Primary Subscriber’s Account Number .................... 5-3
Printer Baud Rate...................................................... 5-11
Program Modes ........................................................... 4-1
Programming Commands ..........................................B-1
PROGRAMMING COMMANDS.................................... 4-1
Programming Entry Errors ......................................... 4-1
Programming Overview .............................................. 4-1
Quick Arm ............................................................. 5-3, 9-1
Quick Exit........................................................................ix
Randomize AC Loss Report ....................................... 5-2
RCVR SETUP ERROR ............................................... 10-4
Real-Time Clock .......................................................... 8-1
Recent Close ............................................................... 1-1
Regulatory Agency Statements .................................A-1
Relay commands......................................................... 6-9
Relay Timeout XXX Minutes ..................................... 5-11
Relay Timeout YYY Seconds.................................... 5-11
Remote P/S Type 13 .................................................... 4-6
REPORT CODE PROG ................................................ 4-3
Reporting Formats .................................................... 3-12
Request to Exit (RTE) Type 12 ................................... 4-7
Reset on Second OFF for Bell 1............................... 5-15
Reset on Second OFF for Bell 2............................... 5-15
Restore Report Timing................................................ 5-7
Restrict Disarming ...................................................... 6-1
RF Receiver Supervision Check-in Interval .............. 5-9
RF System Advisories .............................................. 3-19
RF System Operation and Supervision................... 3-19
RF Transmitter Check-in Interval............................... 5-9
RF Transmitter Low Battery Reporting ..................... 5-9
RF Transmitter Low Battery Sound ........................... 5-9
Ring Count................................................................... 7-2
Ring Detection Count.................................................. 5-4
RINGER EQUIVALENCE .............................................C-1
RJ31X ......................................................................... 3-11
RLY VOICE DESCR ..................................................... 4-3
Scheduling................................................................... 6-1
Scheduling Commands ..............................................B-1
Scheduling Menu Mode .............................................. 6-4
Scheduling Programming Menu Structure ............... 6-5
Scheduling Programming Options ............................ 6-5
Secondary Format....................................................... 5-4
Secondary Phone Number ......................................... 5-3
Secondary Subscriber Account Number .................. 5-7
Send Cancel If Alarm + Off ....................................... 5-10
Serial Number Devices ............................................. 3-17
Serial Number Polling Loop (SL) Type 06 ................. 4-7
Sescoa/Radionics...................................................... 3-12
Sescoa/Radionics Select............................................ 5-5
Setting the Date........................................................... 8-1
Setting the Time .......................................................... 8-1
Specifications..............................................................C-1
Standard/Expanded Reporting Primary .................... 5-5
Standard/Expanded Reporting Secondary ............... 5-5
Standby Battery Size................................................. 3-31
Supervised RF ........................................................... 3-21
Supervised RF (RF) Type 03....................................... 4-7
Supervision Pulses for LRR ..................................... 5-13
Supervisory Messages ............................................. 10-4
Suppress Transmitter Supervision Sound.............. 5-10
Swinger Suppression.................................................. 5-7
System Commands.....................................................B-1
System Communication ............................................. 1-2