Setup guide

Mounting and Wiring the Control

2-1

SECTION 2

Mounting and Wiring the Control

•••••••••••••••••••••••••••••••••

This section describes the procedures for mounting and wiring this control and its peripheral devices.

In the following subsections, procedures are listed in the left column, while notes and pertinent

explanations are provided in the right column.

Cabinet and Lock

1. Mount the control cabinet to a sturdy

wall in a clean, dry area, which is not

readily accessible to the general public,

using fasteners or anchors (not

supplied) with the four cabinet

mounting holes.

2. Remove cabinet door, then remove the

lock knockout from the door. Insert the

key into the lock.

3. Position the lock in the hole, making

certain that the latch will make contact

with the latch bracket when the door is

closed. When correctly positioned, push

the lock until it is held securely by its

snap tabs.

Notes

• The cabinet can be closed and secured without a

lock by using 2 screws in the cover's edge.

CABINET DOOR

BOTTOM

LOCKED

UNLOCKED

cab_lock_snap-001-V0

ADEMCO

PUSH

SNAP

TAB

SNAP

TAB

PUSH

ON LOCK

UNTIL IT

IS SEATED

SECURELY

STEP 2STEP 1

CHECK

POSITION

Figure 1. Installing the Cabinet Lock