Setup guide

Installation and Setup Guide
5-2
PROMPT VALID ENTRIES EXPLANATION
Zn ZT P RC In: L
17 00 1 10 RF: 1
OR
Zn ZT P RC In: AD
17 00 1 10 AW: 07
OR
Zn ZT P RC HW: RT
17 00 1 10 EL 1
Summary Screen
[∗] to continue
A summary display appears.
“IN: L” appears for wireless zones and indicates
input type and loop.
“IN: AD” appears for wired expansion zones (AW)
and indicates the module’s address (AD), which is
based on the zone number.
“HW: RT” appears for basic wired zones and
indicates configuration (EOL, NO, NC, zone
doubling, double-balanced) and response time
selection.
17 Zone Type
Perimeter 03
Zone Type (ZT)
00-24, 77, 82, 90-93 = zone
type (see table at right)
Each zone must be assigned to a zone type, which
defines the way in which the system responds to
faults in that zone.
Enter the Zone Type code from the list below:
Note: If 00 is entered, Delete Zone ? will be
displayed.
00 = Not used
01 = Entry/exit #1 14 = Gas
02 = Entry/exit #2 15 = Medical
03 = Perimeter 16 = Fire w/Verify
04 = Interior Follower 20 = Arm–STAY*
05 = Trouble
Day/Alarm Night
21 = Arm–AWAY*
06 = 24-Hr Silent 22 = Disarm*
07 = 24-Hr Audible 23 = No Alarm Resp
08 = 24-Hr Aux 24 = Silent Burglary
09 = Fire 77 = Keyswitch
10 = Interior w/Delay
81 = AAV Monitor
Zone
12 = Monitor Zone 82 = Blockschloss
*5800 button-type
transmitters only
90-93 = Configurable
17 Partition
1
Partition No. (P)
1-3 = partition
[∗] to continue
Enter the Partition number for this zone.
Partition 1 is shown entered. (3 = Common
Partition).
17 Report Code
1st 01 2nd 00 10
Report Code (RC)
First Digit: 01-09, 10 for A, 11
for B, 12 for C, 13 for
D, 14 for E, 15 for F
00 to disable
Second Digit: same as above
[∗] to continue
Enter the report code for this zone, which consists of 2
hexadecimal digits, each in turn consisting of 2
numerical digits. For example, for a report code of
“10,” enter 01 and 00.
For Contact ID
®
, entering any non-zero entry as the
first digit enables the report code for this zone. Refer
to the System Communication section for
information about report codes and formats.
17 HARDWIRE TYPE
EOL 0
Basic Wired Type
0 = EOL; 1 = NC; 2 = NO
3 = zone doubling (ZB)
4 = double-balanced (DB)
[∗] to continue
This prompt appears only for zone numbers 01-06.
Zone 1 is automatically set for EOL operation.