User manual

13LST700 SERIES USER MANUAL • Approved Document No. DFU7001003 Rev 4
LST700 SERIES FIRE ALARM PANEL
TYPE OF OUTPUT CONNECTED? WHAT HAPPENS WHEN ACTIVATED?
REMOTE OUTPUT
AUXILIARY OUTPUT
FAULT OUTPUT
RESET OUTPUT
SYSTEM SET-UP DATA CHART
1
2
3
4
5
6
7
8
ZONE DESCRIPTION
A concise explanation of the rooms and areas contained in each Zone
DELAY
APPLIED?
COINCIDENCE
(tick if selected)
FIRE ZONE INFORMATION
Yes/No
Yes/No
Yes/No
Yes/No
Yes/No
Yes/No
Yes/No
Yes/No
Yes/No
Yes/No
Yes/No
Yes/No
Important: This page should be carefully completed by an authorised engineer prior to system hand-over.
Any additional information the user needs to know should be entered in this box including repeater location, the
routing of any additional outputs, details of any inputs utilised, etc.
ZONE
NUMBER
OUTPUT ROUTING INFORMATION
ADDITIONAL INFORMATION
THE INFORMATION ABOVE WAS COMPLETED BY (name) _______________________________
OF (company) _________________________________________ ON (date) __________________
LENGTH OF DELAY (1 TO 10 MINUTES) IF APPLICABLE
NOTES ON COINCIDENCE: The following applies to all pairs of zones which are set up for coincidence.
There must be alarms on both zones (i.e. zone 1 and zone 2) before the alarm sounders and outputs turn on. If
only one of the zones (i.e. zone 1) goes into alarm, the panel indicates the alarm by illuminating the relevant
indicator on the front of its enclosure and sounding its internal sounder, thus prompting the user to investigate.
If found to be false, the alarm can be reset or, if found to be a true fire condition, the sounders can be manually
activated by pressing the “Silence/Activate Sounders” button - as detailed on page 8.