User manual

10 LST700 SERIES USER MANUAL • Approved Document No. DFU7001003 Rev 4
LST700 SERIES FIRE ALARM PANEL
Certain fire alarm panel functions can be temporarily disabled (i.e. switched off) to suit prevailing
conditions. For
example, if there is a risk of a false alarm in a zone, say from vehicle exhaust smoke
in a loading bay, it is possible for the user to disable that zone during the risk period and enable it
again afterwards.
Another example is the disablement of outputs during a routine test or temporary
fault.
Following is a list of options that may be disabled by the user at the fire alarm panel and the effect
their disablement will have on how the system works:-
3
4
DISABLEMENTS
To disable or enable any of the above options
Put the fire alarm panel into access level two (see page 6).
Start the selection process by pressing the Next Option button .
The general disablement light will flash and the fault light relating to the first option in the
above table will flash to show it is selected.
If the light flashes at a slower rate than the general disablement light, the option is enabled
If the light flashes at the same rate as the general disablement light, the option is disabled
If necessary, press the Enable/Disable button to toggle the selected option
between disabled and enabled.
To confirm your choice, press the Next Option button .
This will move the selection process on to the next available option in the above table and the
fault light relating to this new option will flash to show it is selected.
The previous option’s fault light will now be lit steady to confirm it is disabled or switched off to
confirm it is enabled.
Repeat steps 2 & 3 for every available option until the selection process is complete.
1
2
OPTION EFFECT ON SYSTEM WHEN DISABLED
Zone 1 Alarms and faults on zone 1 will not be processed
Zone 2 Alarms and faults on zone 2 will not be processed
Zone 3 (only available if fitted) Alarms and faults on zone 3 will not be processed
Zone 4 (only available if fitted) Alarms and faults on zone 4 will not be processed
Zone 5 (only available if fitted) Alarms and faults on zone 5 will not be processed
Zone 6 (only available if fitted) Alarms and faults on zone 6 will not be processed
Zone 7 (only available if fitted) Alarms and faults on zone 7 will not be processed
Zone 8 (only available if fitted) Alarms and faults on zone 8 will not be processed
Fault output Faults will not be transmitted to any other equipment (if fitted)
Remote output Alarms will not be transmitted to remote equipment (if fitted)
Sounders The alarm sounders will not operate in a fire condition
Auxiliary output Alarms will not be transmitted to local fire fighting equipment (if fitted)
Output delays (only available If this option is available, please refer to page 12 for important
if delays have been programmed information regarding delays before attempting to alter this
into the panel by an engineer) function