Specifications

Combined Installation & Operation Guide Honeywell Security
Page 8 of 23 © Honeywell 2004 HMKC-001-01
Press the ‘display’ key to select the next display setting in the cycle of 4x4, 3x3, 2x2 and Picture
in Picture (P-I-P).
Press the ‘sequence’ key to put the DVR output into a sequence. The sequence depends on the
current display mode and set up. If the ‘sequence’ key is pressed again, the sequence stops,
displaying the current step in the sequence.
Press the ‘freeze’ key to freeze the current display. Press the key again to return to ‘live’
picture(s).
1.5 Camera Selection
Press one or two of the number keys (to enter a legal camera number), followed by the ‘camera’
key to select that number camera for full screen display on the DVR output. This also selects
the associated DVR.
Press the ‘camera’ key by itself to increment the camera selection by one.
Note: Both of the above selection processes also make the selected camera the
telemetry camera as shown by the keyboard display. The telemetry camera
can be changed independently of the DVR display camera by putting the
keyboard in telemetry switching only mode. To enable / disable telemetry
switching only mode, press and hold the Fn key, then press the mode key.
(The PTZ LED will light when in telemetry switching only mode.)
1.6 Camera Assignment
See Chapter 6.0 - ”Using the menus” for instructions on using the LCD menu to assign cameras
to DVRs.
1.7 Recording and Playback
The following table indicates the keys used for recording and playback;
Press the ‘search’ key to enter the search menu. Press the key again to exit the search menu.
Press the ‘counter’ key to toggle the DVR front panel display between displaying the time and
the remaining storage capacity.
If the DVR is in playback mode, press and hold the ‘Fn’ key and move the joystick right to play
the video forwards or to the left to play the video backwards. The level of force applied to the
joystick will determine the speed at which the video is played. If the joystick is returned to the
centre position, or the ‘Fn’ key is released, the shuttle is returned to the centre position and the
playback is paused.
Key Function
search Search
play Play / Pause
rw Rewind
ff Fast Forward
stop Stop
rec Record
counter Counter
Fn Function