Specifications

Combined Installation & Operation Guide Honeywell Security
Page 16 of 23 © Honeywell 2004 HMKC-001-01
Note: The range of speeds that can be selected goes from ‘1’ = 1°/sec up to ‘100’ =
100°/sec. To select the maximum seek speed, press ‘0’.
4.6 To Vary the Standard Speeds and Dwell Times of a Tour
For example, to define a tour (As set in 4.5, above.) in memory as ‘Tour 3’ with different dwell
times between preset positions.
Press button ‘3’, then press and hold the ‘autopan’ button. (This will
define ‘Tour 3’.)
Press button ‘1’, then press the ‘preset’ button. (This selects the first
preset in ‘Tour 3’.)
Press button ‘5’, then press button ‘0’, then press the ‘180°’ button.
(This defines 50°/sec to this preset position.)
Press button ‘1’, then press button ‘0’, then press the ‘counter’ button.
(This defines a 10 second dwell time at this preset position.)
Press button ‘2’, then press the ‘preset’ button. (This selects the second
preset in ‘Tour 3’.)
Press button ‘1’, then press button ‘0’, then press button ‘0’, then press
the ‘180°’ button. (This defines 100°/sec to this preset position.)
Press button ‘1’, then press button ‘6’, then press the ‘counter’ button.
(This defines a 16 second dwell time at this preset position.)
Press button ‘3’, then press the ‘preset’ button. (This selects the third
preset in ‘Tour 3’.)
Press button ‘2’, then press the ‘180°’ button. (This defines 2°/ sec to
this preset position.)
Press button ‘1’, then press button ‘4’, then press the ‘counter’ button.
(This defines a 14 second dwell time at this preset position.)
Release the ‘autopan’ button.
The tour is now set up. To operate ‘Tour 3’
Press button ‘3’, then press the ‘autopan’ button.
Note: The range of the dwell times that can be set varies from 1 to 254 seconds.
Entering a time of ‘0’ will select 1 second dwell time.
4.7 Alarm Activation during Tour Programming
If an alarm is activated on a camera whilst any keyboard is being used to program a tour for that
camera, the programming will be interrupted at the point of activation. (The tour will also
require re-programming.)
4.8 To Stop a Tour of Presets
Press the ‘autopan’ button. (This will turn off the tour.)
The tour will also stop if the telemetry buttons or the joystick are used to control the camera.
4.9 To Restart a Tour of Presets
Press the ‘autopan’ button. (This will start the last tour that the unit was carrying out.)