Specifications

Honeywell Security Combined Installation & Operation Guide

4.3 To Start a Tour of Presets

A Microsphere can store four different preset tours. After programming the tours, as detailed in

the next sections, they may be recalled in the following way.

Press the number button that corresponds to the tour number, either ‘1’,

‘2’, ‘3’, or ‘4’.

Press the ‘autopan’ button.

4.4 To Define a Simple Tour

For example, to define a tour for three preset positions in memory as ‘Tour 1’.

First, define the three preset positions, as detailed in section 4.1, above.

Press button ‘1’, then press and hold the ‘autopan’ button. (This will

define ‘Tour 1’.)

Press button ‘1’, then press the‘preset’ button. (This selects the first

preset in ‘Tour 1’.)

Press button ‘2’, then press the ‘preset’ button. (This selects the second

preset in ‘Tour 1’.)

Press button ‘3’, then press the ‘preset’ button. (This selects the third

preset in ‘Tour 1’.)

Release the ‘autopan’ button.

The tour is now set up. To operate ‘Tour 1’

Press button ‘1’, then press the ‘autopan’ button.

The tour will now be set with a standard speed of 30°/sec and the dwell time at each preset set

to a standard 60 seconds.

4.5 To Vary the Standard Speed of a Tour

For example, to define a tour (As set in 4.4, above.) in memory as ‘Tour 2’ with different speeds

between preset positions.

Press button ‘2’, then press and hold the ‘autopan’ button. (This will

define ‘Tour 2’.)

Press button ‘1’, then press the ‘preset’ button. (This selects the first

preset in ‘Tour 2’.)

Press button ‘5’, then press button ‘0’, then press the ‘180°’ button.

(This defines 50°/sec to this preset position.)

Press button ‘2’, then press the ‘preset’ button. (This selects the second

preset in ‘Tour 2’.)

Press button ‘1’, then press button ‘0’, then press button ‘0’, then press

the ‘180°’ button. (This defines 100°/ sec to this preset position.)

Press button ‘3’, then press the ‘preset’ button. (This selects the third

preset in ‘Tour 2’.)

Press button ‘2’, then press the ‘180°’ button. (This defines 2°/sec to

this preset position.)

Release the ‘autopan’ button.

The tour is now set up. To operate ‘Tour 2’

Press button ‘2’, then press the ‘autopan’ button.