Specifications

Combined Installation & Operation Guide Honeywell Security
Page 12 of 23 © Honeywell 2004 HMKC-001-01
2.6 Camera Selection
Pressing a number followed by the ‘camera’ key selects a camera to display. This intelligently
selects the associated multiplexer (e.g. if camera 18 is selected and camera 18 is assigned to
input 2 on multiplexer 2 then the second input on multiplexer 2 is selected).
Pressing the ‘camera’ key alone increments the camera selection.
Note: Both of the above selection processes also make the selected camera the
telemetry camera as shown by the keyboard display. The telemetry camera
can be changed independently of the Multiplexer display camera by putting
the keyboard in telemetry switching only mode. To enable / disable telemetry
switching only mode, press and hold the ‘Fn’ key, then press the ‘mode’ key.
(The PTZ LED will light when in telemetry switching only mode.)
2.7 Camera Assignment
See for instructions on using the LCD menu to assign cameras to multiplexers.