Specifications

Combined Installation & Operation Guide Honeywell Security

Page 10 of 23 © Honeywell 2004 HMKC-001-01

Multiplexer Operation

2.0 Multiplexer Control Functions

2.1 Multiplexer Mode

Press the ‘mode’ key to toggle between Multiplexer and DVR mode.

2.2 Multiplexer Selection

Pressing a number followed by the ‘Fn’ key selects a multiplexer to control. This intelligently

selects the last camera controlled on that multiplexer (or the first camera input on that

multiplexer if it has not been selected previously).

2.3 Menus

Press the ‘F1’ key twice, then select ‘setup’ to enter the multiplexer set-up menus. Navigation

around these menus is achieved by using the function keys as indicated in the following table;

Press the ‘F1’, ‘F2’, ‘F3’ or ‘F4’ keys to move around the menu pages. Press the ‘F5’ set key to

select an option within the menus.

To exit the menus (except the main menus), select exit in the menu and then press the ‘F5’ set

key. To exit the main menus, select ‘cancel’ in the menu and then press the ‘F5’ set key. (This

will return the unit to normal operation.)

Press the ‘F6’ esc key whilst in the main menus only to exit (and return to normal operation).

Key Function

F1 Up

F2 Down

F3 Left

F4 Right

set

Set

esc

Esc