Operating instructions

5.4.4 Operational test
It the keyboard is connected as instructed in the section “ Connection” it should be immediately possible to
switch the video inputs using the video/telemetry controls.
5.4.5 Matrix setup
It is only possible to modify matrix setup using VKR-KB1 or VKR-KB2 ENEO type keyboards.
5.4.6 Possible types of installations
5.4.6.1 Telemetry control by the matrix alone
While configuring the keyboard, the COMMUNICATIONS / TELEMETRY submenu (see § 4.2.3.2
-Telemetry , page 24), should be set as follows:
A-Connector
Telemetry
A-Protocol -------------------
A-Baudrate -------------------
B-Connector Telemetry
B-Protocol -------------------
B-Baudrate -------------------
All telemetry commands will be sent to the matrix which in turn will send them along the P&T line. The
telemetry protocol is set in the video matrix.
5.4.6.2 Telemetry control by the keyboard alone
Page 59 of 193 MNVADCT_0409