Operating instructions

CAMERA
Used to select the active camera.
Only accepted cameras can be recalled (see § 4.2.4.1.4 - Cameras with connection to
multiplexer, pag.30).
MULTIPLEXER
Used to select the active multiplexer.
Only accepted multiplexers can be recalled (see § 4.2.4.2.3 - Multiplexer ( direct connection
with multiplexer), pag.31).
This control only makes sense if the multiplexer is identified by an address.
5.1.1.3 Multiplexer controlled by a video device
In the figure below the keyboard is controlling the matrix and shows the key for recalling multiplexer
controls. The active controls are matrix controls (see § 5.1.1.1 - Matrix connected to the video connector,
pag.53).
Active matrix control area
RECALL MULTIPLEXER
Used to pass from matrix controls to multiplexer controls.
In the figure below the keyboard is controlling the multiplexer and shows the key for recalling multiplexer
controls. The active controls are the multiplexer controls ( see § 5.1.1.2 - Multiplexer connected to the video
connector, pag.53 ). Accepted multiplexers and cameras are defined in the external multiplexer (see § 4.2.4.3 -
Multiplexer cameras, pag.32 e see § 4.2.4.4 - External multiplexer , pag.33).
Specific control area for selected multiplexer
Active multiplexer control area
RECALL MATRIX
Used to pass from multiplexer controls to matrix controls.
Page 55 of 193 MNVADCT_0409