Operating instructions

4.4.7.1.1 Change Preset
The change Preset menu is used to store, in the controlled device, the various positions to be taken by the
dome/receiver.
Each position is associated with a number so that when the operator uses the SCAN control for recall, he can
position the dome/receiver at the previously stored point..
The available number of storage positions depends on the controlled device. To verify the limits of the devices
present in your system, see the sections referring to the connected devices (see § 6 - TELEMETRY, pag.95).
Keys for directly recalling specific
functions from this menu
Procedure f or inserting a Preset position:
 position the camera in the desired position using the other available functions in the top of the display if
necessary
 insert a value within the maximum and minimum limits shown on the display and confirm with the
ENTER key
To insert other positions or to change a previously inserted position, repeat the procedure from the beginning
4.4.7.1.2 Cancel Preset
The cancel Preset menu is used to delete a single Preset position stored in the controlled device. This type of
function is not present in all devices.
Procedure f or deleting a Preset position:
 insert a value within the maximum and minimum limits shown on the display and confirm with the
ENTER key
Page 49 of 193 MNVADCT_0409