Operating instructions

4.2.4.2.4 Individual multiplexers (direct connection with multiplexer)
Position the cursor to correspond with the multiplexer to be modified and press the key.
If the multiplexer has been deactivated it will be activated and vice versa.
Exit menu key
Cursor shift key
Cursor shift key
Monitor activation/deactivation key
4.2.4.3 Multiplexer cameras
This menu is used to set the cameras that can be selected by the keyboard.
T he keys can be used to simultaneously activate/deactivate all the cameras on the page, on one line only or to
enter the submenu to activate individual cameras.
T he status of the activated camera is indicated by the presence of the letter A or B to show that the camera is
connected to telemetry A or B.
WARNING: If the camera present in the system is fixed (not equipped with Pan & Tilt
movement), if it is to be operated it must be associated with one of the two telemetries (A or B).
Exit menu key
Cursor shift key
Cursor shift key
Individual camera modification key
Keys for shifting up/down the cameras
.
.
Key for deactivating all the cameras on the page
Key for activating all the cameras on the page
Key for activating the whole line corresponding to the cursor position
Key for deactivating the whole line corresponding to the cursor position
Telemetry A connector selection key
Telemetry B connector selection key
Use the or keys to select the connector to which the cameras are connected and proceed to activate the
cameras using the row or page keys. T o activate/deactivate individual cameras press the key .
For connection with devices other than the SW128/16 matrix, setting monitors and cameras
beyond the physical limits of the connected devices will be accepted but will have no effect on the
devices themselves.
Page 33 of 193 MNVADCT_0409