Operating instructions

6.18 Procedure for setting a dome/receiver in operation
How to proceed:
1. Configure to enable telemetry setup (see § 4.2.4.5 - Functions, pag.34).
2. Make sure the device to be installed is among those compatible with the keyboard (see a partire dal § 6.3
- ELMO Dome, pag.107).
3. Install the device as instructed in its installation manual.
4. Consult the particular sections in this manual concerning how to make the connections and any notes on
particular settings for the device to be controlled (for example: protocol, baud rate, etc).
5. For the device to be controlled, configure the physical address of the device so that it is different from all
other devices connected on the same RS485 line.
6. Connect the keyboard directly to the dome/receiver as instructed, on one of the two telemetry connectors.
7. In the keyboard parameters configure the device protocol, selecting the appropriate connector and setting
the same baud rate (see § 4.2.3.2 - Telemetry, pag.24).
If these parameters are configured incorrectly communication between the devices is impossible.
8. Exit keyboard setup mode and select the camera number corresponding to the address setting for the
dome/receiver, or if the address is greater than the maximum number of inputs allowed for the matrix
proceed to re-address the dome (see § 6.1.2.3 - Change address number associated with the camera,
pag.96).
9. Operate the joystick to make sure the typical PAN/TILT/ZOOM controls are recognised by the controlled
device.
10. In the corresponding chapter, verify the enabled controls for the specific device and the possibility of direct
keyboard setup (vedi § 6.1.5 - Organising the configuration menus, pag. 98).
Page 193 of 194 MNVADCT _0409
Signature
Alessio Grotto
(President)