Operating instructions

SETUP PATROL STANDARD
Enters the setup menu for the Standard Patrol function
SETUP PATROL SA
Enters the setup menu for the Patrol SA function
6.17.9.1 Setup Standard Patrol
The Patrol sequence is represented by a series of Preset positions that are performed in succession with the
same pause (dwell time) for each position.
The Standard Patrol can have a maximum of 14 positions.
T he Patrol change only becomes effective after completing transmission of the configuration to the receiver.
Procedure for configuring the Standard Patrol:
 To enable the position, position the cursor next to the Preset position to be enabled and press the key.
 To change the pause length go to the item “ Pause” and press the key. Insert the desired value and
confirm with the ENTER key.
 To send the configuration, position the cursor on the item “ Send configuration” and press the key.
 Exit the menu and start the Standard Patrol.
6.17.9.2 Setup Patrol SA
The Patrol sequence is represented by a series of Preset positions that are performed in succession with a pause
(dwell time) between each position.
The Patrol SA can have a maximum of 40 positions.
T he Patrol change only becomes effective after the changed parameter has been sent..
Procedure for configuring Patrol SA for the Preset positions:
 Position the cursor next to the item “ Patrol start”, press the key and insert the desired value.
 Position the cursor next to the item “ Patrol End”, press the key and insert the desired value.
 To send the configuration, position the cursor next to the item “ Send Configuration”and press the
key.
Page 190 of 193 MNVADCT _0409