Operating instructions

6.15 ENEO receivers
6.15.1 Reference material
ENEO VPT -42/RS1 telemetry receiver.
6.15.2 Configuring the receivers
Configure the receiver appropriately as described in the corresponding manual.
Connect the receiver directly to the keyboard and a monitor to the dome video output following the general
procedure (see § 6.18 - Procedure for setting a dome/receiver in operation, pag.191).
6.15.3 Connecting the hardware
T he ENEO receivers can be connected directly to the keyboard using one of the telephone cables supplied with
the keyboard (for testing and control) or using the standard connection cable, for distances up to 1200 m (see §
3.3 - One keyboard per line: standard connection cable, pag.16).
6.15.4 Autopan
From the MAIN menu press the AUTOPAN key to enter the menu for carrying out the specific function.
START AUTOPAN
Carries out the related function.
STOP AUTOPAN
Stops the patrol function in progress.
SETUP AUTOPAN
Access to the Autopan function setup menu
For correct Autopan operation the Preset number 63 and Preset number 64 have to be set. With
these Preset numbers the stop positions for the Autopan will be defined.
Page 175 of 193 MNVADCT _0409