Operating instructions

6.13.8.1 Setup Group
The following procedure is valid for all 6 TOURs.
Procedure for adding a position to the selected TOUR :
 Select the first parameter, press the ENTER key and when the numeric keypad appears set the PRESET
number to reach the dome.
 Select the second parameter, press the ENTER key and use the keypad to set the speed used to reach the
position.
 Select the third parameter, press the ENTER key and use the keypad to set the duration of the pause when
the position is reached
 Select “ Send position” and press the ENTER key to send information to the dome.
 To add other positions repeat from the beginning.
Finally press the ESC key to return to the TOUR performance screen.
Procedure for deleting the GROUP.
 Select the delete TOUR command line and confirm by pressing the ENTER key
Press the ESC key to exit the menu
6.13.8.2 Setup Tour
Procedure for setting up the TOUR function:
 Position the cursor next to the GROUP that is to be enabled in the TOUR function and press the ENTER
key. Enabled status is shown as a filled dot.
 Send the Configuration to the dome by positioning the cursor on the send command line and press the
ENTER key.
Press the ESC key to exit the menu.
Procedure for deleting the TOUR.
 Select the delete TOUR command line and confirm by pressing the ENTER key.
Press the ESC key to exit the menu.
Page 167 of 193 MNVADCT _0409