Operating instructions

6.12 SENSORMATIC Dome
6.12.1 Materials and reference documents
Sensormatic DeltaDome II Dome
Rs-422/RS-485 Communication Protocols, 8000-2694-01, Rev.A
6.12.2 Connecting the dome hardware
White RS485A Rx+
Yellow RS485B Rx-
6.12.3 Configuration
The dome is mostly configured by On Screen Menu.
Some parameters can be configured by inserting a special code.
For all dome configuration operations SETUP TELEMET RY must be enabled.
Connect the dome directly to the keyboard and a monitor to the dome video output following the general
procedure (see § 6.18 - Procedure for setting a dome/receiver in operation, pag.191).
Go to the dome OSM configuration screen.
T he screen that appears allows access to dome OSM configuration.
ENTER PROGRAMMING
Used to enter the dome OSM.
EXIT PROGRAMMING
Used to exit the dome OSM.
FOCUS NEAR
To be used as indicated in the dome manual (selecting the submenus).
FOCUS FAR
To be used as indicated in the dome manual (selecting the submenus).
To move within the menus use the joystick.
ZOOM is used to increase/decrease the field values and move the cursor to the left or right when
defining the text.
Page 158 of 193 MNVADCT _0409