Operating instructions

6.11.7 Preset, Scan and Home
Important note!
The 'Scan' instructions given in the dome manual do not correspond to the generally accepted
usage in this manual: for practical purposes the functions take on the 'standard' meaning and not
those suggested by the dome manual:
 ‘preset’ means to store the current position
 ‘scan’ means the pan & tilt movement to a previously stored position; in the dome manual
this position is called 'preset'
 'autopan' means the dome movement described as 'auto scan'
The PRESET, SCAN and HOME functions are as described in the general explanation with the following
limitations specific to the dome (see § 4.4.7.1 - Preset, pag.47 e see § 4.4.8 - SCAN MENU, pag.49).
Type Minimum position Maximum position Notes
PRESET 1 240
SCAN 1 240 In the event of joystick operation the
dome carries out the movement in
progress until it reaches the recalled
preset position.
HOME Carries out the function specified in
OSD
6.11.8 Patrol (Tour and Pattern)
From the MAIN menu press the PATROL key to enter the menu for carrying out the movement controls.
START TOUR/PATTERN
Used to carry out PAT ROL.
The only way to stop the movement in progress is to operate the joystick (Pan or Tilt movements)
Page 157 of 193 MNVADCT _0409