Operating instructions

6.11 SANTEC Dome
6.11.1 Connecting the dome hardware
White RS485A TX+
Yellow RS485B TX-
IMPORTANT NOTE
Configure inside the dome the Fastrax II Protocol.
6.11.2 Configuration
The dome is mostly configured by On Screen Menu.
For all dome configuration operations SETUP TELEMET RY must be enabled.
Connect the dome directly to the keyboard and a monitor to the dome video output following the general
procedure (see § 6.18 - Procedure for setting a dome/receiver in operation, pag.191).
Go to the dome OSM configuration screen.
T he screen that appears allows access to dome OSM configuration.
ENTER PROGRAMMING
Used to enter the dome OSD
The remaining keys have the same functions as those of the original keyboard. The reader should refer to the
specific manual for the dome.
Page 154 of 193 MNVADCT _0409