Operating instructions

6.9 SAMSUNG Dome
6.9.1 Materials and reference documents
Samsung SCC-64-1P - SCC643P Dome
Samsung Protocol
6.9.2 Connecting the dome hardware
SCC64-1P
White RS485A Txd+
Yellow RS485B Txd-
SCC643
White RS485A Rxd+
Yellow RS485B Rxd-
For the SCC643 Dome configure FULL DUPLEX mode. If required by the system it is possible
to configure HALF DUPLEX mode: in this case the connection is identical to that of the SCC64-
1P Dome, on poles Txd+ and Txd-.
6.9.3 Configuration
The dome is mostly configured by On Screen Menu.
For all dome configuration operations SETUP TELEMET RY must be enabled.
Connect the dome directly to the keyboard and a monitor to the dome video output following the general
procedure (see § 6.18 - Procedure for setting a dome/receiver in operation, pag.191).
Go to the dome OSM configuration screen.
T he screen that appears allows access to dome OSM configuration.
ENTER PROGRAMMING
Used to enter the dome OSM .
EXIT PROGRAMMING
Used to exit the dome OSM .
FOCUS / IRIS
Used to perform the corresponding functions during the PRESET positions phase.
Page 144 of 193 MNVADCT _0409