Operating instructions

6.8 PELCO Dome
6.8.1 Materials and reference documents
Spectra II 3.31 Dome
Pelco Protocol Manual, “ D” Protocol, March 2, 1999
6.8.2 Connecting the dome hardware
White
RS485A
Rx+
Yellow
RS485B
Rx-
IMPORTANT NOTE
The dome should be configured to use the “D” Type Protocol.
6.8.3 Configuration
The parameters can be configured by inserting a special code (see the corresponding section).
For all dome configuration operations SETUP TELEMET RY must be enabled.
Connect the dome directly to the keyboard and a monitor to the dome video output following the general
procedure (see § 6.18 - Procedure for setting a dome/receiver in operation, pag.191).
6.8.4 Autoflip
From the MAIN menu press the AUTOFLIP key to enter the menu for carrying out the specific function.
START AUTOFLIP
Carries out the corresponding function.
Page 139 of 193 MNVADCT _0409