Operating instructions

6.7.4 Configuration
The dome is mostly configured by On Screen Menu.
Some parameters can be configured by inserting a special code.
For all dome configuration operations SETUP TELEMET RY must be enabled.
Connect the dome directly to the keyboard and a monitor to the dome video output following the general
procedure (see § 6.18 - Procedure for setting a dome/receiver in operation, pag.191).
Go to the dome OSM configuration screen.
T he screen that appears allows access to dome OSM configuration.
ENTER PROGRAMMING
Used to enter the dome OSD menu.
EXIT PROGRAMMING
Used to exit the dome OSD menu.
RESET ALL
Reset all
SPECIAL MENU 600/850
T o be used to enter the SPECIAL dome menus (camera).
ESC MENU
Used to exit the submenus.
ENTER MENU
Used to enter the submenus and to confirm data changes.
FOCUS NEAR/FAR
Carries out the FOCUS NEAR and FOCUS FAR. functions
ZOOM+/-
Carries out the ZOOM+ and ZOOM- functions.
UP / DW / LFT / RGT
Arrow Up, Down, Left and Right respectively, to be used to move within the menus.
Page 132 of 193 MNVADCT _0409