Operating instructions

6.4 ERNITEC SATURN Dome
6.4.1 Materials and reference documents
Ernitec Saturn Dome
ICU Installation Instruction, Manual No.3040-00014, Rev.980220
6.4.2 Connecting the dome hardware
White
RS485A
Rx+
Yellow
RS485B
Rx-
6.4.3 Configuration
The dome is mostly configured by On Screen Menu.
Some parameters can be configured by inserting a special code.
For all dome configuration operations SETUP TELEMET RY must be enabled.
Connect the dome directly to the keyboard and a monitor to the dome video output following the general
procedure (see § 6.18 - Procedure for setting a dome/receiver in operation, pag.191). Go to the dome OSM
configuration screen.
T he screen that appears allows access to dome OSM configuration.
ENTER PROGRAMMING
Used to enter the dome OSM.
UP/DOWN ARROWS
To shift within the dome menus and change the values
LEFT/RIGHT ARROWS
Correspond to the Previous and Next keys shown in the dome manual.
ENTER MENU
Used to enter the submenus and to confirm data changes.
Page 115 of 193 MNVADCT _0409