Operating instructions

6.3 ELMO Dome
6.3.1 Materials and reference documents
D7720B-J1P Dome
Surveillance Control Protocol (DSCP), ver2.4, 2001.05.25
6.3.2 Connecting the dome hardware
White
RS485A
Red
Yellow
RS485B
Black
Red
GND
Green
WARNING
Both telephone cables (the one connected to the keyboard and also the one connected to the dome)
are those supplied as accessories to the DCT keyboard!
DO NOT USE the grey telephone cable supplied with the Elmo dome. Using the grey cable (with
the consequent pin connection error shown in the diagram) may damage the keyboard, because the
dome also supplies 12VDC power along the RJ11 connector as well as the usual RS485 signals.
6.3.3 Configuration
The dome is mostly configured by On Screen Menu.
Some parameters can be configured by inserting a special code.
For all dome configuration operations SETUP TELEMET RY must be enabled.
Connect the dome directly to the keyboard and a monitor to the dome video output following the general
procedure (see § 6.18 - Procedure for setting a dome/receiver in operation, pag.191).
Go to the dome OSM configuration screen.
T he screen that appears allows access to dome OSM configuration.
ENTER/EXIT PROGRAMMING AND CONFIRM “ENTER”
Used to enter the dome OSM menu and submenus.
Page 109 of 193 MNVADCT _0409