Operating instructions

6.1.3 Communication problems between keyboard and receiver
If a receiver does not respond to the controls check the following:
 does the receiver model connected to the telemetry line (A or B) use the protocol setting for the telemetry
line?
 does the receiver number correspond to the one shown on the display?
 does the receiver baud rate correspond to the setting for the telemetry line?
 does the telemetry line in question output to a video cable or a dedicated connector?
 has the connection between keyboard and receiver been made correctly?
 if passing through an SM matrix, has the matrix been configured correctly?
The information concerning which device is being controlled is easy to obtain by using the key (see §
4.2.7 - System Information and service menu, pag.42).
6.1.4 Conventional terminology
The terms “ Video programming”, “ On Screen Menu” and “ OSM” should be considered as equivalent.
In the users' manuals for the domes they are used indifferently.
The term "toggle" means “ reverse the status”: if a parameter is active, after a “ toggle” it will be deactivated
and vice versa.
T he term “ camera” and “ telecamera” should be considered as equivalent.
6.1.5 Organising the configuration menus
T he domes and receivers can be configured in the following modes:
 On Screen Menu (OSM)
 Special codes
T he access menu is organised in the same way for all the devices. T he following is an example for a dome.
SPECIAL CODES Menu OSM
Page 100 of 193 MNVADCT _0409