Operating instructions

To be able to change the camera address, CHANGE address must be enabled (see § 4.2.4.5 - Functions,
pag.34). Then the camera recall screen will show an additional key that gives access to readdress mode.
Key for access to readdress mode
When the key has been pressed the screen will ask for the camera number which is to have an address change.
In the example, the address of camera No. 2 is to be changed. When the desired number has been keyed in it
should be confirmed with the ENTER key.
At this point the system asks for the insertion of the address number. In the example the number is 81.
New camera address
Old camera address
Press the ENTER key.
T he system returns to showing the active camera selection screen and camera 2 has address 81.
NOTES:
 If the address of the active camera is changed, the camera must be recalled again so as to
activate the address change.
 The address number should correspond to the address setting for the device to be controlled.
Set the DIP SWITCHES of the receiver or dome appropriately.
Page 99 of 193 MNVADCT_0409