Setup guide

TouchCenter Installation and Setup Guide
5–22
TouchCenter can hold the identity for 10 Users in its memory. If
additional Users are needed, define the additional Users using the
Console Emulation Mode.
Users for the system are programmed in a central user setup location
that provides the specific questions for authorization levels assigned to
different users. You may want these users to be the same, but there are
situations in which you may want a user to have limited capabilities.
These capabilities are defined by the Authority Level assigned to each
user.
Authority Levels
Authority levels define the system functions a particular user can
perform. Depending on the authority assigned to you, there are certain
system functions you may be prohibited from performing. The following
information describes the authority levels available in the TouchCenter
and provides the equivalent authority level name that you will find if you
are reading your alarm system manuals. The authority levels available in
the TouchCenter are as follows:
Equivalent System Name Touch-
Center
Authority
Level
Functions
Residential
Systems
Commercial
Systems
Installer Can perform all security functions except
can only disarm if code was used to arm,
can change Master Code, cannot change
other user codes, can access the Central
Station Screen options
Note: This authority level cannot be
assigned using the TouchCenter
Installer Installer
Master Can perform all security functions,
add/delete users in assigned partition,
program scheduled events, and change
partition master code
Partition
Master
Level 1 Master
Normal Perform security functions (arm, disarm) Standard
User
Level 3
Operator A
Guest Can arm the system in assigned partitions,
but cannot disarm the system unless the
system was armed with this code.
Note: Do not assign this level if Quick Arm
is enabled in the system.
Guest Level 4
Operator B
No Access Used to restrict access to a partition. N/A N/A