Setup guide

SECTION 5: Setup
5–15
Safe Mode
The Safe Mode may be automatically entered by the TouchCenter
program on a communication failure or may be entered manually on
command. The following paragraphs describe these entry processes.
Automatic Entry
In the rare event that the TouchCenter cannot successfully
communicate in its graphic mode with the control panel, the
TouchCenter presents you with a message of “Problems detected. Start
Keypad in Safe Mode?” and requests a “Yes” or “No” response. If you
answer with “Yes”, the TouchCenter will go into the Safe Mode. If you
answer with “No”, the TouchCenter will try communicating with the
panel again. After 3 consecutive times of receiving no response, the
TouchCenter will enter the Safe Mode automatically.
Manual Entry
Note: ONLY enter the Safe Mode from the Normal Mode. Entering the
Safe Mode from the Demo Mode may result in incorrect display of the
Emergency Function keys.
To manually put the TouchCenter into the Safe Mode of operation:
1. From the "Home" screen, press the Setup button. The "Setup" screen is
displayed.
SCREEN ACTION
2. Press the System Setup button. The
“System Setup” screen is displayed.
3. Press the CS Setup button. The “CS
Setup” screen is displayed.
4. Press the "Options" button. The
“Operating Modes” menu screen is
displayed.