Setup guide

SECTION 3: Front Panel LEDs and Navigation Icons
3–3
Panel Fault Displays
The “Security” screen displays an Icon(s) if a panel fault(s) occurs.
The fault Icon is displayed to the left of the Panic button. The
following Icons may be shown as applicable to your system:
ICON MEANING
AC Loss – The system is not receiving AC power.
Bell Failure – The system bell or siren has a problem. Note: This
Icon will be displayed when interfacing with residential panels only.
Expander Failure – The system has a failure in an expansion
module.
Low Battery – The system battery, that powers the system during an
AC power loss, is low.
LRR Supervision Failure – The Long Range Radio used to commun-
icate with the central station has a supervision failure.
Max Attempts Exceeded – The system has exceeded the maximum
attempts to communicate with the Central Station.
Pager Failure – The system cannot communicate with an assigned
pager.
Telco-1 Cut – The system is not able to communicate with the
central monitoring station over the primary phone line.
Telco-2 Cut – The system is not able to communicate with the
central monitoring station over the secondary phone line.
Wireless Failure – The system is not able to communicate with its
wireless devices.
Note: Fault Icons will scroll between all faults present on the system, if multiple
faults exist.