User`s manual

– 99 –
Holiday Programming Up to 16 holidays can be defined for the system. After entering Scheduling Menu
Mode, press 0 until the Holidays ? prompt appears.
Holidays ?
1 Yes 0 = No 0
Enter 1 to program holiday schedules.
HOLIDAY NUMBER ?
01-16,00=Quit 01
Enter the 2-digit holiday number to be programmed and
press * to accept entry.
Enter 00 then * at the Holiday Number prompt to quit the
Holiday menus and display the Quit ? prompt.
Enter 0 at the Quit ? prompt to
return to the main menu choices
and continue programming. Enter
1 to quit Scheduling Menu Mode.
Quit ?
1 = YES 0 = NO 0
01 ENTER DATE
00/00
The cursor will be positioned on the tens of months digit.
Enter the appropriate month, then press * to proceed to
the day field. Enter the appropriate day for the holiday
and press * to accept the entry.
Part ? 12345678
Hit 0-8 x x
Holidays can be set for any partition as follows. Press 0 to
turn all partitions on or off, or else use keys 1-8 to toggle
the letter x under the partition to which this holiday will
apply. Press the * key when all desired partitions have
been assigned.
The Holiday Number prompt will be displayed again.
Repeat the procedure for each holiday to be
programmed.
When all holidays have been programmed, enter 00 at the HOLIDAY NUMBER
prompt to quit the holiday menus.
Time-Driven Event
Programming
The following schedules can be used to activate outputs, bypass zones,
arm/disarm the system, etc. based on a time schedule. Up to 20 events can be
programmed for the system.
Note that the following menu items must be programmed using #93 Menu Mode -
Relay Programming:
• Enter Relay No. (reference identification number)
• Relay Group (if applicable)
• Restriction
• Relay Type (4204 or X-10)
• House code and Unit code if X-10 devices
• ECP address and specific Relay No. if 4204 relays
After entering Scheduling Menu Mode, press 0 until the Timed Events ? prompt
appears.
Timed Events ?
1 Yes 0 = No 0
Enter 1 to program timed events using relay outputs or X-
10 devices.
TIMED EVENT # ?
01-20,00=Quit 01
Enter the timed event number to be programmed (01-20)
and press the * key. The system will then prompt the user
to enter the desired action to be taken.
Enter 00 at the TIMED EVENT prompt to quit the timed
event menus and display the Quit ? prompt.
Enter 0 at the Quit ? prompt to
return to the main menu choices
and continue programming. Enter
1 to quit Scheduling Menu Mode.
Quit ?
1 = YES 0 = NO 0