User`s manual

– 112 –
SUMMARY OF ARMING MODES
Mode Features For Each Arming Mode
Exit Entry Perimeter Interior
Delay Delay Armed Armed
AWAY Yes Yes Yes Yes
STAY Yes Yes Yes No
INSTANT Yes No Yes No
MAXIMUM Yes No Yes Yes
Access Control If programmed, one relay may be used for access control. To activate this relay,
the user enters his user code + [0]. The relay will pulse for 2 seconds.
Delay Closing Time If open/close schedules are used, end users can manually extend the closing
window by up to 2 hours. This is useful if a user must stay on the premises later
than usual. User must have authority level of manager or higher.
To extend the closing window, enter user code + # +82. The following will be
displayed.
Closing Delay ?
Hit 0-2 Hours
Enter the number hours, 1 or 2, by which the end of the
closing window should be delayed. Note that the delay is
from the scheduled closing time, not from the current time.
Press * to accept entry and exit this mode. Press # to exit this
mode without changes.
The system will send a "Schedule Changed" message to the
central station when the closing window is delayed.
Important: The delay cannot be reduced once it is set. It can
only be increased. This is to prevent the user from deleting
the delay after the normal window expires, thereby missing
the end of the window.
Partition "Goto" Commands Each console is assigned a default partition for display purposes, and will show
only that partition's information. To see information for another partition, or
perform system functions in another partition, use the GOTO command (code +
[*] +partition number 0-8). The console will remain in the new partition until
directed to go to another partition, or until 120 seconds has elapsed with no
keypad activity.
View Capabilities Of A User The console will display the partitions that user is authorized for, the user
number, and the authority level for all partitions authorized. Enter code + [Q] +
[Q]. The user's capabilities in each authorized partition will typically be displayed
as follows:
Part. 1 WHSE
User 01 Auth.=1.
The user's Open/Close report capability is shown by the dot following the
authority level. If Open/Close is not enabled for a user, the dot will not appear.
Viewing Downloaded
Messages
Users may occasionally receive messages on the console display from their
installation company. When this occurs, the console will display "Message. Press
0 for 5 secs.". Instruct the user to press and hold the 0 key to display the central
station's message. Note that the system must be in the READY state to view
these messages.
Using The Built-In User's
Manual
An abbreviated User's Manual is stored in the system's memory, and can be
particularly useful to the end user if the printed User's Manual is not conveniently
accessible when the user needs to perform a seldom used and unfamiliar system
procedure. The Built-in User's Guide is displayed by simply pressing any of the
function keys (e.g., OFF, AWAY, STAY, MAXIMUM, BYPASS, INSTANT, CODE,
TEST, READY, #, and CHIME) for approximately 5 seconds and then releasing it.
Abbreviated instructions relative to the key that has been pressed will then be
displayed (2 lines of text are displayed at a time). This function operates in either
the armed or the disarmed state.