User's Manual

4
u Wearing the Neckloop
u Charging the Neckloop
Place the wire around your neck and insert the round
connector plug into the Neckloop Quick Disconnect plug,
forming a loop.
To have the Neckloop operate properly, you
will need to be sure the Quick Disconnect connection jack
has been securely clicked in place.
IMPORTANT:
The Neckloop has a built-in rechargeable Li-Polymer
battery. It is recommended to fully charge the battery prior to
the first time use of the device.
Connect one end of the USB cable into the charging
port of the unit, then connect the other end into the USB
jack of base charger. Plug the base charger into a
standard AC wall outlet .
The unit is fully charged when the light goes out. After a
full charge, remove the charger from the wall outlet and
detach the USB cable from the unit.
(See Diagram 1)
1.
2.
Way 1: Using AC Power Supply
Diagram 1
8. Quick Reference Guide
MFB Press
LED Indicator
Blue
Red
Hold 3s
Hold 3s
Hold 6s
Flash 4x
Flash 4x
Blue Flash 4x, Red/Blue
Alternating for 2 mins
Flash 4x
Flash 2x
Hold 1.5s
Twice
After Beep Tone, say voice tag
Once upon
ring tone
Hold 1.5s
Flash 3x/2s
Flash 3x/2s
Once
Connecting
to phone
Flash 2x
Once
Current
OFF
ON/Standby
OFF
Pairing
Standby
Standby
Standby
Call
Incoming
Call
Incoming
Talk
Standby
Playing
Standby/
Talk
Next
Power On
Power Off
Pairing
Pairing Passed
Connected to
the Phone
Last Number
Redial
Voice Dial
Answer
Reject
End Call
Playing
Pause
Low Battery
Flash 1x/30s
User State
15