User guide

54
Features
Handheld, rugged, lightweight •
Wave ID (auto identification & switching) •
Triple, dual, or single Wave ID, CW, Tone •
270 Hz, 330 Hz, 1 kHz, 2 kHz Tone •
Large LCD with backlight (OPM4-4D) •
Power measurements in dBm or µW; •
insertion loss in dB
Reference power level storage •
Low battery indicator •
Long battery life with 2 x AA alkaline •
Cost-effective, easy to use •
N.I.S.T traceable •
Applications
Passive Optical Networks (PON) testing •
Certify single-mode links per TIA/EIA •
standards
Fiber identification prior to splicing •
SLP4 Triple Wave Test Kits with Wave ID
and Set Reference
The SLP4 triple wavelength single-mode test kits are available in two models, SLP4-FTTH
and SLP4-7. The SLP4-FTTH and SLP4-7 model combine the OPM4-4D optical power
meter and either OLS7-FTTH (1310/1490/1550 nm) or OLS7-3 (1310/1550/1625 nm)
LASER source respectively.
The OLS7-FTTH and OLS7-3 feature a triple wavelength LASER output from a single port
and are easy to operate. Each wavelength may be transmitted individually at CW or with
user selectable modulated Tone. Also, each wavelength may be transmitted with Wave ID.
When transmitting with Wave ID, the OLS7 will also support transmitting pairs of wave-
lengths in an alternating pattern and triple wavelengths in a sequential pattern. Associated
with each operating condition, the designated LED indicator will illuminate to identify the
currently enabled operating mode and emitted wavelength wavelength(s) along with bat-
tery charge status and external power presence. The OLS7-FTTH & OLS7-3 output ports
are equipped with UCI based removable adapters to allow the output connectors to be
inspected and cleaned.
The OPM4-4D features automatic wavelength identification and switching (Wave ID)
when used with the OLS7, multiple test Tone detection for fiber identification, and stores
optical references for each calibrated wavelength. A large dual-wavelength LCD display
with backlight shows measured power [dBm or µW] or insertion loss [dB], calibrated
wavelengths [nm], tone signal [Hz], wavelength ID, and estimated remaining battery life.
The OPM4-4D optical input port accepts a variety of Noyes thread-on style adapter caps
(ordered separately) to meet a wide range of testing requirements.
The OPM4-4D and OLS7 offer long battery life from common AA alkaline batteries.
The SLP4-7 and SLP4-FTTH kits are fully N.I.S.T. traceable.
Ordering Information
MODEL INCLUDES
SLP4-7 OLS7-3 optical light source, OPM4-4D optical power meter, AA batteries, protective rubber
boots, adapter cap, SLP4-7 test kit user's guide, and carry case.
SLP4-FTTH OLS7-FTTH optical light source, OPM4-4D optical power meter, AA batteries, protective rubber
boots, adapter cap, SLP4-FTTH test kit user's guide, and carry case.
Test jumpers and connector adapters are required for operation (purchased separately).
Test jumpers with a variety of connector styles and fiber types and adapter caps for most
common connectors may be purchased from AFL Telecommunications.
continued on the next page