User guide

26
C860 QUAD OTDR and Certification Test Kit C860 QUAD OTDR and Certification Test Kit
GENERAL C850 OTDR C840 TESTER
Test Modes OTDR (Full Auto, Expert,
Real-Time), Auto Test, OPM,
OLS, VFL
Auto Test,
OPM, OLS, VFL
Trace File Format SR-4731 (GR-196-CORE
Appendix A, B; SR-4731)
N/A
Length Measurement Range 5 km (MM);
200 km (SM)
Data Storage Internal flash memory
USB flash drive (2.0)
Downloadable from unit directly to PC
Data Storage Capacity Internal > 1000 fibers
Data Transfer to PC USB
Tool Free Adapters Modular cleanable SC/ST/LC
Size 27.4 x 19.3 x 7.1 cm
(10.8 x 7.6 x 2.8 in)
23 x 11 x 7 cm
(8.8 x 4.3 x 2.8 in)
Weight 2.3 kg ( 5 lb) 0.9 kg (2 lb)
Operating Temperature -10 to +50°C, 0 to 90% RH (non-condensing)
Storage Temperature -20 to +60°C, 0 to 90% RH (non-condensing)
Power Rechargeable Li-Ion or AC power adapter
Battery Life
1
> 8 hours continuous testing
Recharge Time
2
4 hours
Display 16.51 cm (6.5 in),
color, transflective
9.65 cm (3.8 in),
color, transflective
1 Typical, depending on display brightness.
2 Typical, from fully discharged to fully charged state, unit may be operating.
External battery charger available.
VISUAL FAULT LOCATOR
Emitter Type Laser
Safety Class Class II FDA 21 CFR 1040.10 and 1040.11,
IEC 60825-1: 2007-03
Wavelength 650 nm
Output Power (nominal) 0.8 mW
POWER METER
Calibrated Wavelengths 850, 1300 1310, 1490, 1550, 1625 nm
Detector Type InGaAs 2mm
Measurement Range +6 to -60 dBm
Accuracy
1
±0.25
Measurement Units dB, dBm, mW
Wavelength ID
2
Yes (to -47 dBm)
Set Reference Yes
Data Storage Yes
Tone Detection Yes (to -47 dBm)
1 Accuracy measured at 25ºC and -10 dBm per N.I.S.T. standards.
2 Automatic wavelength identification and switching when used with Noyes Wave
ID Series Light Sources.
LIGHT SOURCE MULTIMODE PORT SINGLE-MODE PORT
Available Wavelengths 850/1300 nm (nominal) 1310/1550 nm (nominal)
Emitter Type LED Laser
Safety Class Class I FDA 21 CFR 1040.10 and 1040.11,
IEC 60825-1: 2007-03
Output Power > - 20 dBm, 62.5µm
MM
1
0 dBm, 9µm SM
Stability (after 15
minutes warm up)
± 0.1 dB over 1 hour ± 0.07 dB over 1 hour
± 0.15 dB over 8 hours
Wave ID Transmit Yes
Tone Generation 270 Hz, 330 Hz, 1 KHz, 2 kHz
1 Output power will be approximately 3 dB less if a 50 µm mandrel-wrapped
jumper is used instead of a 62.5 µm mandrel-wrapped jumper.
Specifications
(All specifications valid at 25°C unless otherwise specified)
OTDR MULTIMODE SINGLE-MODE
Emitter Type Laser
Safety Class Class I FDA 21 CFR 1040.10 and 1040.11,
IEC 60825-1: 2007-03
Center Wavelengths 850/1300 nm 1310/1550 nm
Wavelength Tolerance ± 20/30 nm ± 20/30 nm
Dynamic Range (SNR = 1) 22 dB 26 dB
Event Dead Zone
1
1.5 m
Attenuation Dead Zone
2
9 m
Pulse Widths 10, 30, 100, 300 ns; 1, 3, 10 ms
Range Settings 250 m to 64 km 250 m to 208 km
Sampling Points Up to 16,000
Min. Data Point Spacing 0.25 m
Group Index of Refraction (GIR) 1.4000 to 1.6000
Distance Uncertainty (m)
3
± (1 + 0.005% x distance + data point spacing)
Linearity ± 0.05 dB/dB
1 Typical distance between the two points 1.5 dB down each side of a reflective
spike caused by a -45 dB event using 10 ns pulse width.
2 Typical distance from event location to point where trace is within 0.5 dB of
backscatter caused by a -45 dB event using 10 ns pulse width.
3 Does not include GIR uncertainty.