Technical data

050100-Rev000-M50010 6
Set zero
By using the Zero key eventual irregularities occurred after start up the scale can be compensated by
setting the display back to zero.
Hold function
Press the Hold key in case of unstable readout which might occur in case of too heavy agitation on
the platform. The scale will hold the result displayed. After leaving the scale the fixed weight is still
displayed and can be noted. Deactivate the HOLD function by pressing the key again.
Unit function
By using the Units key you may select the weighing mode (kg, lbs, st).
Cleaning, Maintenance and Re-approval
Cleaning
Before cleaning make sure the scale has been disconnected from the socket.
For cleaning just use a damp cloth or common disinfection products.
Do not use any aggressive cleaning fluids.
Make sure no water or cleaning fluid penetrates the scale.
Service
Display indication Lo Recharge the power-pack by connecting the mains adapter to the display.
Display indication ErrL Check correct positioning of the scale (see chapter installation & use of scale)
and make sure the scale is completely unloaded.
Display indication Err Function test does not automatically lead to `0.00´. Try zero setting key. If
display still indicates Err the scale needs calibration. Please contact your local
dealer or service partner.
Display indication ErrP Severe failure of weighing system. Please contact your local dealer or service
partner.
Safety instructions
Do NOT use the scale
• If the mains adapter shows visible damages
• If mains adapter is not working properly
• After long storage in humid places
In those cases contact your local dealer or service partner.
Storage and Transport
Keep all original parts and pieces for an eventual sending back of the scale in order to avoid any
possible damage during transport which automatically leads to no warranty.
Disconnect all cables before transport to avoid unnecessary damages.