User Guide

How to Unset the system
When you enter your premises you will need to unset (or turn off) the system. If your system had
gone into alarm then be aware that intruders may be in the premises. Seek assistance before
investigating the cause of the alarm and unset the system.
5
Logic Six intruder system
Panel
Offer keyfob
to the Panel
and withdraw
Keyfob recognition beep
Enter your premises by the route recommended
by your installer. The system will produce an
entry beep tone.
Offer a to the Panel and withdraw it as
soon as you hear the beep
tone from the local sounder.
The system will stop the entry beep tone and
light the green LED.
If any Zone, Tamper or Attack LEDs light
up then an alarm has occurred, and an intrusion
may have taken place. Seek assistance before
investigating further as intruders may still be
on the premises. The first alarm indication
given by a flashing indicator, with all subsequent
alarm indication given as a steady indication.
These indications will remain until the next time
the system is unset.
keyfob
keyfob recognition
Day
Note the panel LEDs will flash consecutively
from left to right, from to the LED,
during Unset operation.
Zone1 PA
Entry beep
Day
Power
n
Day
TA PA
Power
1 2 3 4 5 6
TA
PA
ZONE