User Guide

How to Set the system
When you leave your premises you will need to set (or turn on) the intruder alarm system. Before
setting the system you should ensure that the premises have been completely vacated and that all
doors and windows are closed. Ensure that pets do not have access to the protected areas as they
can cause a false alarm, unless pet immune detectors have been used, ask your installer for more
information.
4
Operating instructions
Panel
Offer keyfob
to the Panel
and withdraw
Keyfob recognition beep
The indicator should be lit at the Panel.
Offer a to the Panel and withdraw it
as soon as you hear the
from the local sounder.
The system will produce the exit beep
tone and you should leave the premises by
the exit route recommended by your installer.
The system will set when the exit beep tone
stops.
Day
keyfob
keyfob recognition
beep tone
Note the panel LEDs will flash consecutively
from right to left, PA to Zone1 LED during Set
operation. If however there is an open zone
then the relevant ZONE LED will be lit and a
sound indication is given. If this is the case
then investigate the cause and ensure all
zones are closed.
Insistent Exit beeps
(for final 10 seonds)
Once any operation is performed
using the keyfob withdraw it away
from the panel, wait for
duration before next use of the
keyfob to operate the system.
3 seconds
Power
Day
Power
The external strobe will operate for ,
which provides a confirmation of SET operation.
5 seconds
Exit beep
1 2 3 4 5 6
TA
PA
ZONE