User Guide

How to learn keyfobs if none are recognised
16 4188-753 issue 1_1/03
Engineering information
Offer the slightly touching it on the centre depression
of the A learnt indication is given of the when
the flashing LED changes to steady On indication
and there is a recognition beep given by the local sounder.
Shortly after the next numbered LED starts flashing.
Withdraw the learnt keyfob.
next keyfob
Panel. next keyfob
ZONE
ZONE
You now have up to to learn the10 seconds next keyfob.
keyfob recognised beep
Panel
Next
keyfob
Hold the slightly touching it on the centre depression
of the .
first keyfob
Panel
Once the is acknowledged by the
the LED changes from flashing to steady and there is
a recognition beep given by the local sounder. Withdraw the learnt
keyfob. The is now ready to learn the ,
signalled by LED flashing.
first keyfob Panel
Panel next keyfob
ZONE 1
ZONE 2
keyfob recognised beep
Panel
first
keyfob
x 5 rapid beeps
Now remove the link between Z1 and Set.
x 2 beeps
Hold
Ensure the is connected to the intruder system and the
link is fitted on the
Power up the intruder system you will hear five rapid beeps to
acknowledge the is in the .
Panel
Panel PCB between Z1 and Set.
Panel Learn mode
The will NOT timeout until the first keyfob is learnt.learn mode
You will only need to learn keyfobs in this manner if no keyfobs are recognised by the
You must have all the keyfobs to be
learnt available. Keyfobs can be learnt by each installed in a system
Panel.
Panel
A can
learn up to 8 keyfobs following power up of the intruder system.
Panel
POWER UP THE SYSTEM
Power
Day
1
Learn
1
ZONE
-
STROBE
J6
+
TA
SCB
DB
BELL
+
-
SET
1 2
Learn
1
Learn
2 3
Repeat to learn the next keyfob.
Once all the keyfobs are recognised ‘learnt’ by the Panel wait
for just over and the Panel will exit the10 seconds learn mode,
this is announced by two beeps from the local sounder and return
to Day mode indication.