User's Manual

SABRE

™

RANGER 5000 User Guide

12. Web Console in Safe Mode

Safe Mode is a simple version of the normal Web Console with some basic settings.

If you could not access the Web Console in normal way, you can try to access the Web Console in

the Safe Mode.

ENABLING SAFE MODE

There are two methods for enabling the Safe Mode.

Method 1: Enter Safe Mode through Web Console (Normal Mode)

i. With the terminal powered on, connect personal computer to the SABRE

™

RANGER 5000 via

Ethernet cable.

ii. Login to Web Console by typing http://RANGER5000 or http://192.168.1.35 into the address

bar of any web browser.

iii. Navigate to Menu > Settings > Terminal Settings> Firmware Upgrade to perform a firmware

upgrade. Your terminal will reboot in Safe Mode once you click the Firmware Upgrade button.

iv. If Safe Mode is enabled successfully, the Antenna Pointing LEDs are solid green.

v. Login to the Web Console in safe mode by typing http://RANGER5000 or http://192.168.1.35

into the address bar of the web browser again.

Method 2: Enter Safe Mode through physical buttons.

i. With the terminal off, press and hold ‘Safe Mode Switch’.

Figure 71

ii. In parallel, power up the terminal.

iii. Release ‘Safe Mode Button’ after 5 seconds.

iv. If Safe Mode is enabled successfully, the Antenna Pointing LEDs are solid green.

v. Login to the Web Console in safe mode by typing http://RANGER5000 or http://192.168.1.35

into the address bar of any web browser.

NOTE:

The username and password of the Web Console are the same for Normal Mode and Safe Mode.

Safe Mode Switch