Manualshelf

User's Manual

ManualsBrandsADDVALUE INNOVATION ManualsElectronicsSatellite Terminal, iSavi
11121314151617181920
Page 14 of 49
Audio Assisted Pointing Mode
1. The terminal is in LED visual pointing mode by default. To switch into Audio assisted
pointing mode, press and hold ‘Exit Pointing Mode’ button for 5 seconds.
2. The four arrow LEDs will change into flashing green pattern when antenna pointing audio
mode is activated, refer Appendix A: Antenna Pointing LED Status Table.
3. The beeping sound indicates the signal strength. The frequency of the beeping will become
higher when the signal is stronger.
4. First, tilt the terminal up to 45 degrees from the horizontal.
5. Now turn the terminal slowly until the beeping frequency is maximized.
6. Finally, tilt the terminal up or down and fine tune the position onto further increase the
beeping frequency.
7. ‘Exit Pointing Mode’ button will turn to flashing green when the signal strength is good
enough for network registration.
8. Press the ‘Exit Pointing Mode’ button to exit antenna pointing mode and start network
registration.
9. Once the network is registered, all the four tilt and turn LEDs will turn off after one minute
and ‘Exit Pointing Mode’ button is green colour.
Note:
You can switch back to LED Visual Pointing Mode when the global beam is not acquired by
pressing the ‘Exit Pointing Mode” button for five seconds before registered to network.
You are recommended to use Appendix A: Antenna Pointing LED Status Table as a guideline.
Once the network is available, all the four tilt and turn LEDs will turn off after one minute.
The LEDs of ‘Power’ button and ‘Exit Pointing Mode’ button may sometimes hard to see under
bright sunlight.
Antenna Pointing using the IsatHub Control app
1. Before using this method, download the application from App Store or Google Play for iOS
or Android devices respectively. Data downloaded over the iSavi is chargeable, so use a
free data service to acquire these apps where possible.Refer to GETTING STARTED.
2. Open the Control app with smart phone or tablet.
3. Follow the on screen instructions and press ‘Pointing assist’ for specific help.