User's Manual

FX500R / FX 500 / FX250 Installation cum Operation Manual

Page 6 of 43

Proprietary Information Not To Be Disclosed Without Written Authorisation From

SAFETY INSTRUCTIONS

For the sake of safety and protection, read the manual before attempting to use the FBB User

Equipment (UE).

The following general safety precautions must be observed during all phases of operation,

service and repair of this equipment. Failure to comply with these precautions or with specific

warnings elsewhere in this user guide violates safety standards of intended use of the UE.

Addvalue Innovation Pte Ltd assumes no liability for the customer's failure to comply with

these requirements.

Hazard Symbols

Heated Surfaces

Avoid touching those areas of the UE that are being

marked with this symbol otherwise it may result in injury.

Antenna Radiation Warning

and Distance to other

Radiation Equipment

For safety reasons, all personnel must keep at least 2

meters from the antenna.

Power Supply

Turn off the power at the mains switchboard before

beginning of the installation.

Confirm the power voltage is compatible with voltage

rating of the UE. It is highly recommended to use +24V

DC power line, provided that it is available on the vessel.

In case of unavailability of +24V DC power line provided

by the vessel, an external AC/DC power supply of

115/230V AC with its output of +24V DC can be used.

Note: The requirements of the AC/DC power supply

should take care of high surge current of 25A at 24V

DC for 1ms.