User's Manual

FX500R / FX 500 / FX250 Installation cum Operation Manual

Page 20 of 43

Proprietary Information Not To Be Disclosed Without Written Authorisation From

In case of the existing mast’s flange in a vessel or ship does not fit the ADU’s mounting

base’s holes, a mechanical adaptation flange/plate is to be designed and custom-made,

which acts as an interface between the existing mast and the ADU.

2.1.6 Installing Antenna Unit

The antenna unit is carefully unpacked and checked for any damage.

For the FX 500 terminal, 35-meter antenna cable is to be checked.

For the FX 250 terminal, 25-meter antenna cable is to be checked.

For FX 500 Antenna Unit,

The procedure of the installing the antenna unit is as follow:

 Attach the coaxial cable to the RF connector of the antenna unit’s bottom.

 Lift the antenna unit to the mounting location.

 Lay the rubber mat on the mast’s mounting base.

 Let the coaxial cable being laid through the mast internally.

Cut

hole Dimension

for

Clearance holes for M6 ( Recommended >

6.5mm)

Custom

made

mechanical adaptation

flange