User's Manual

Getting Start
• Connect the cables and accessories as show
in Terminal Simplified Block Diagram.
• Insert a Thuraya SIM card, with the gold
printed circuit facing down and switch on
Atlas IP Terminal.
• User can access the web console when the
Terminal LED turns blinking green while
other LEDs turn green.
• System is ready for normal operation at the
defaulted DATA mode.
Selecting DATA or VOICE Mode
• On the Web Console,
Settings>Admin>System Operation Mode,
there are 2 modes of “Data” and “Voice”.
• Select DATA mode for browsing internet,
emailing, etc.
• Select VOICE mode for initiating a voice call
using a Primary Handset.
Note: Switching between DATA and VOICE mode, it will
take about 2 to 3 minutes to take effect.
Using Primary Handset
• On the Web Console,
Settings>Admin>System Operation Mode,
click “Voice” and then “Update Settings”.
• On the primary handset, dial phone number
in the format: <00><Country
Code><Telephone Number> .
• Disconnect the call by pressing the key.
Sending an SMS using Primary
Handset
• Select Menu>Messaging>OK>New
message>OK. Enter your test message using
the keypad
• Select OK > Send.
• Enter the destination mobile number
format: <00><Country Coode><Telephone
Number>
OR
Select OK to choose an existing contact and
then select OK to send text message.
Activating Wi
-
Fi Setting using Web
Console
• Select Settings>Wi-Fi.
• Select Enabled and click Update.
• Use a Wi-Fi Enabled device to search for
Network Name (SSID): Wideye-GenericAP.
• On the device, select connect to the network .
BDU LEDs States
Terminal:
• Blinking Green: BDU is functioning.
• Steady Red: BDU powers up or detects
failure.
Antenna:
• Steady Green: ADU is functioning.
• Steady Red: ADU detects failure.
• No Light: ADU is calibrating.
Registered:
• Steady Amber: Registration to network in
progress.
• Steady Green: Registered to network
Data:
• Steady Green: In Data Mode, user can
browse internet.
• No light (Off) : In Data Mode, user cannot
browse internet.
In Voice Mode, user can
initiate a voice call using
The Primary Handset.
Useful Password Reference:
• Web Console Username: admin (Default)
• Web Console Password: admin (Default)
• Terminal Pin: 000000
Also applies to Factory Reset and Boot up
password.
3