User's Manual
Atlas IP Terminal Installation Manual
Page 30 of 34
4.4 Selection of Data / CS Voice Mode
The terminal is set as Data as the defaulted mode upon powering up the terminal.
The Data mode is used for user to browse internet, email, ftp etc.
The Voice mode is used for user to make a voice call via Primary Handset. There are 2 ways
to switch from Data mode to Voice mode;
Web Console*
Select Settings>Admin>System Operation Mode, click radio button of “Voice” and
then Update Settings.
For switching back from Voice to Data mode, click radio button of “Data” and then
Update Settings.
Primary Handset’s Mode Key*
On Primary handset’s “Mode” key, press it to switch from “Data” to “Voice” mode to
make a voice call. Press it again to switch back from “Voice” to “Data”.
*
Note:
Setting from “Data” to “Voice” mode via Web Console or Primary Handset, it will take at least 2 minutes to take effect. Likewise for
switching from “Voice” to “Data” mode.
Mode Key