User's Manual

Atlas IP Terminal Installation Manual
Page 29 of 34
Click Settings and set the following:
For the data connection, under the Ethernet mode, enable radio button of “Router Mode
(Multi-User)” which is with NAT/PAT enabled for multi-user.
Note:
The Router settings cannot be changed while the Data connection is active. The Data session must be first disconnected.
Click Update to allow the selection to take effect.
 Click Refresh to query the current mode.
Click Connection
To activate the PDP context, click “Activate Default Profile”.
The data connection will be activated with a notification of the public IP address assigned to
the active data connection. An user may now browse the internet, do file transfer (FTP) or run
any IP-based application services.
To disconnect the data connection, click Disconnect.
The PDP context will be deactivated.